Brukere som er tagget i denne tråden

Thanks Thanks:  0
Viser resultater 1 til 6 av 6

Tråd: Fitting interior from an S60 R into a ph1 V70

  1. #1
    Registrerte brukere
    Medlem siden
    16. jan. 2011
    Innlegg
    137
    Antall takk

    Standard Fitting interior from an S60 R into a ph1 V70

    Anyone got any experience in adapting the interior from a later car (S60 R) into an earlier estate (V70R)?.. I've been offered an set of seats out of an S60R, I'm fairly sure the front seats should fit but I'm wondering if I could use the covers off the rear seats to recover the V70R rear seats?

  2. #2
    kimove sin avatar
    Medlem siden
    17. jan. 2010
    Sted
    Saltdal
    VCCN medlemsnummer
    405
    Innlegg
    1.594
    Antall takk

    Standard

    Sitat Opprinnelig postet av Tomcat Vis post
    Anyone got any experience in adapting the interior from a later car (S60 R) into an earlier estate (V70R)?.. I've been offered an set of seats out of an S60R, I'm fairly sure the front seats should fit but I'm wondering if I could use the covers off the rear seats to recover the V70R rear seats?
    As i remember Kilroy here on this forum did this conversion to his ph1 v70 But there has been no activity in his thread for quite some time :(
    Teori e når man veit allt og ingenting funger.
    Praksis e når allt funger og ingen veit kofør.
    Å me dette så førenes teori og praksis.
    Ingenting funger og ingen veit kofør.

  3. #3
    Registrerte brukere Anders Dybvadsskog sin avatar
    Medlem siden
    19. des. 2009
    Sted
    Verdal`n
    VCCN medlemsnummer
    2634
    Innlegg
    4.663
    Antall takk

    Standard

    http://forum.vccn.no/showthread.php?...ghlight=Kilroy

    Look at the last 10 pages maybee here
    740 prosjekt: http://forum.vccn.no/showthread.php?t=392

    Ny eier av Dunfrid<3

  4. #4
    Moderator Daniel V sin avatar
    Medlem siden
    05. jan. 2010
    Sted
    Sarpsborg
    VCCN medlemsnummer
    287
    Innlegg
    9.585
    Antall takk

    Standard

    I know he took the dash from a s60R and instrumentpanel, but its not looking good. The dashboard in S60/V70R is allot wider than the firstgen V70. Kilroy tried to modify it. It looks good in his thread, but irl it looks horrible. I dont know about the seats.
    Mvh Daniel V. Volvo 444 PV 1958

  5. #5
    Registrerte brukere
    Medlem siden
    16. jan. 2011
    Innlegg
    137
    Antall takk

    Standard

    Sitat Opprinnelig postet av Daniel V Vis post
    I know he took the dash from a s60R and instrumentpanel, but its not looking good. The dashboard in S60/V70R is allot wider than the firstgen V70. Kilroy tried to modify it. It looks good in his thread, but irl it looks horrible. I dont know about the seats.
    Yeah I've seen the dash and as you say it probably looks ok from a distance but I doubt it'll look good up close, that and it sticks out into the doorway quite a bit.

  6. #6
    mrstfu sin avatar
    Medlem siden
    13. feb. 2010
    Sted
    Rotnes, Norway
    VCCN medlemsnummer
    273
    Innlegg
    12.594
    Antall takk

    Standard

    I was told about a trick an old friend of my uncles used to do... heat up each end of the dash, have two guys in the backseat kicking the damn thing into place, and let it cool down. Like a glove

Lignende tråder

  1. an fitting på FK dyserail.. Hva må til?
    By daols1 in forum Motor og gir
    Svar: 2
    Siste post: 13/09/12, 10:07

Regler for innlegg

  • Du kan ikke starte nye tråder
  • Du kan ikke svare på innlegg / tråder
  • Du kan ikke laste opp vedlegg
  • Du kan ikke redigere meldingene dine
  •