Brukere som er tagget i denne tråden

Viser resultater 1 til 4 av 4

Tråd: V70 2001 front noise

Threaded View

Forrige innlegg Forrige innlegg   Neste innlegg Neste innlegg
  1. #1
    Registrerte brukere
    Medlem siden
    18. april 2018
    Innlegg
    5
    Antall takk

    Standard V70 2001 front noise

    I bought V70 for wife to get more confident in driving. A safe, simple, good car.

    During weekend we drove the car and it started to make clicking noise on the front left. The sound has not been there earlier, we have driven 700km so far. It makes a ticking sound where the frequency of the tick corresponds to the speed of the car. The sound does not happen when accelerating but does appear when coasting (steady speed) or when engine breaking (engine breaking triggers the sound and it is the loudest during engine breaking). The sound does not happen when wheels are turned but only when they are straight (or between certain semi-straight angle). Changing to different gears or having the clutch down, makes no difference to the sound. Breaking does not affect the sound either.

    The sound started when my wife drove, not being experienced, and the
    ETM
    has slightly bad zone at low rpm, so she did lot of acceleration/deceleration cycles and not super-smooth driving like experienced driver. I guess this ramming (and the quite bumpy road agitated the car) My guess is that it could be the joint on the left side drive shaft, CV axle or whatever it is called, the part transferring the torque to the wheel from gearbox.

    On the way back I drove (more smoothly and on better roads) and gradually the sound got more and more silent and almost unnoticeable.

    Anyway I am interested to hear if anyone has ideas of the cause. Also recommendations on where to have it fixed for cheap. If it is the shaft, it is quite easy to replace, no? I have no place/tools to fix it myself. The part itself is quite expensive if one buys new one. So aftermarket parts could be good option for me. OR is it possible to take it off, clean, add new grease and some rubber bushings set to protect it? The part would not need to last long, I do not plan to use the car for more than a year. So any advice or recommendations or offers would be much appreciated.

    I will after work today check the condition of the rubber bushing that keeps the axle grease in and dirt out, it should be broken if I'm right about the cause?
    Sist endret av Thya; 30/04/18 kl 16:40

Lignende tråder

  1. 740 -92 Ny front til gammel front
    By Timmern94 in forum 700 / 900 / x90 -serien
    Svar: 1
    Siste post: 30/08/17, 06:45
  2. Fra 90+ front til 89- front, 740
    By Avfallskverna in forum Karosseri, interiør og bilpleie
    Svar: 0
    Siste post: 28/12/16, 00:15
  3. Bygge om fra ny front til gammel front på 740?
    By Buer24O in forum Karosseri, interiør og bilpleie
    Svar: 0
    Siste post: 28/01/14, 23:30
  4. Ledningsnett -> Bytte fra 90' 740 front til 940 front
    By The Bear in forum 700 / 900 / x90 -serien
    Svar: 10
    Siste post: 01/08/12, 20:39
  5. am./canada-front for 240 Ø.K.front er kjøpt, kan slettes
    By mamolv in forum K: 100 / 200 -serien
    Svar: 16
    Siste post: 23/03/10, 07:49

Regler for innlegg

  • Du kan ikke starte nye tråder
  • Du kan ikke svare på innlegg / tråder
  • Du kan ikke laste opp vedlegg
  • Du kan ikke redigere meldingene dine
  •