Diagnosetegninger/REGINA

[aleksvattoy]

Noen som vet om hvor jeg kan finne en tegning/bruksanvising til feilkode/diganose bruksanvisnig til REGINA innsprøytning,
sammer som denne:
http://forum.vccn.no/showthread.php?t=650, bare til REGINA ikke LMM.

[jan_m]

Table 3: Regina Fuel Injection Fault Codes. Read these from socket 2:

Fault Codes Fault Condition Source of Fault
1-1-1 No faults
1-1-2 Fault in control unit FI control unit
1-1-3 Fault in injector Fuel injector
1-2-1 Signal missing or faulty to/from pressure sensor MAP Pressure sensor
1-2-2 Signal missing or faulty to/from air temperature sensor Air temperature sensor
1-2-3 Signal missing or faulty to/from coolant temperature sensor, possible grounding short ECT Coolant temperature sensor
1-3-2 Battery voltage too high/low Check battery and charging system
1-3-3 Throttle switch: idle setting faulty, possible grounding short TPS Throttle switch
2-1-2 Oxygen sensor signal missing or faulty Oxygen sensor
2-1-3 Throttle switch: full load setting faulty; possible grounding short TPS Throttle switch
2-2-1 Oxygen sensor not operating Oxygen sensor or intake air leak
2-2-2 Fault in fuel injection relay Fuel injection relay
2-2-3 Signal missing to/from idle valve IAC Idle air control valve
2-3-1 Self-adjusting oxygen sensor not operating Intake air or fuel system
2-3-2 Self-adjusting oxygen sensor not operating Intake air or fuel system
2-3-3 Idle valve closed IAC Idle air control valve
2-4-1 EGR system malfunction (California cars) EGR vacuum booster
3-1-1 Signal missing from speedometer Speedometer signal
3-2-1 Signal missing to/from cold start valve Radio suppression relay
4-1-3 EGR temperature sensor circuit (California cars) EGR temperature sensor
du tar ut feil koder på stikk 2 til motor stikk 1 er invendig og lh 2.4 funker som instruksjon:)

[aleksvattoy]

Hjertelig takk... Finnes det i Norsk tekst og?

[jan_m]

ja vet jeg skal ha det et sted men var det jeg fant fort og geli